These 3.5" slip-on exhaust tips are the perfect choice for easily dressing up your exhaust outlets. Made from stainless steel and equipped pressure clips so they go on easily and stay in place just like the factory tips. No ugly screws or clamps for a clean appearance. These exhaust tips are sure give your factory exhaust a grand look without spending the big bucks for a complete system.

Not for use with M-Performance exhaust systems.

Dimensions

F-N55B58-ET-AC-GB - 21 x 19 x 10.5cm

F-N55B58-ET-SC-BT - 21 x 19 x 10.5cm

Weight

F-N55B58-ET-AC-GB - 0.9 Kg

F-N55B58-ET-SC-BT - 0.94

BMW 1 Series (NON-USA MODEL ONLY)

• 2012+ BMW F20 F21 N55 M135i
• 2013+ BMW F20 F21 B58 M140i

BMW 2 Series
• 2014+ BMW F22 F23 N55 M235i/ix
• 2017+ BMW F22 F23 B58 M240i/ix

BMW 3 Series
• 2012+ BMW F30 F31 N55 335i/ix
• 2016+ BMW F30 B58 340i/ix
• 2012+ BMW F34 GT N55 335i/ix

BMW 4 Series
• 2014+ F32 F33 N55 435i/ix
• 2014+ F36 Gran Coupe N55 435i/ix

Not for use with M-Performance exhaust systems.

Remove your factory tips by pounding outward on the lower part of the tip with either a rubber mallet or a hammer. A small piece of wood can also be used between the hammer and the exhaust tip edge. This is done from under the rear of the car. Small medium taps will start the factory tip sliding off the actual exhaust pipe. Secure the tip before it comes off the end of the pipe with your hand. Make sure to keep it straight to not damage the inner spring clips. The cutout must be facing straight or at 45º depending on where your alignment dowell is. Slide the BMS slip-on exhaust tip straight over the factory exhaust pipe. Carefully push the tip straight on until it stops. The tips should completly hide the pipe edge. You may want to cover the edge of the tip with a folded towell and lightly pound with a rubber mallet. 

F-N55B58-ET

Manufactured by

Burger Motorsports

Warranty

BMS do not offer warranty on this product.